1. Dismantle
Before installing the smart door lock, we need to use a screwdriver to remove the old lock first, after the screw is loose, it will be faster to twist it by hand, and be careful not to damage the door lock hole when disassembling.
2. Initial installation and measurement
After removing the old lock, you need to "try" install the lock body of the electronic door lock into the security door. During the installation process, it is necessary to measure the width and thickness of the door panel and the new lock body, and mark the hole on the door according to the volume of the existing door lock and the position of the bolts.
3. Hole opening, hole drilling
After measuring the relevant data, the lock body needs to be taken out, and the steel body of the security door needs to be cut with an angle grinder or disc sander. The installation site was full of sparks, and the noise that came with it was needless to say.
4. Install the lock body and calibrate
All of the above is preparation, and then the real installation process is next. The lock body needs to be fixed first, and a second calibration is required before it is fully fixed. The position of the deadbolt should match the original door frame, and the most important thing is that the door lock should not be tilted.
5. Install the front and rear panels
The seemingly simple panel installation is actually the core of "intelligence". The lock body and the panel need to be fixed with large bolts, and there are connecting lines between the front and rear panels, so that intelligent unlocking is formed. In addition, it is necessary to install waterproof rubber mats, etc.
6. Trial + Password
After all the debugging is completed, you need to set up the smart door lock, in order to ensure the safety of your home, be sure to change the original password and enter the administrator's fingerprint information. Any operation requires a password or fingerprint to determine its administrative privileges.
