1. The wing gate to determine the plan. When communicating with customers, determine the plan, how much is the width of the site, how much is the length, how many machines can be installed, whether to choose the vertical wing gate, or the bridge wing gate, the vertical wing gate dimensions: 420x330x980 (mm), the bridge wing gate dimensions: 1200x280x1000 (mm), the wing gate rod to the chassis size 510mm, that is, the vertical wing gate covers an area of 420x (330 + 510), the bridge wing gate covers an area of 1200x (280 + 510), When determining the selection, fully consider the gap between the turnstile and the gate rod, the area of each wing gate, the location, how to route (whether to take the bright line or the dark line), the plan is set, the goal is set, and the wing gate is waiting for the gate to arrive at the scene.
2. The fixed position wiring. According to the previously determined scheme, clarify the specific size of the installation of the wing gate, do a good job of embedding the pipe, leave a gap of 50-100mm between the turnstile and the turnstile, and open the upper cover to prevent the adjustment of the machine, maintenance, etc., must not leave a gap, between the turnstile and the turnstile embedded 2 6-8 points of plastic pipes, one hose to the power line (strong electricity), the other hose to the signal line (weak electricity), can not take the power line and the signal line at the same time a hose, which will affect the effect of communication, The embedded pipe should be 30-40mm high above the ground, and the wiring vertical wing gate should be at the bottom of the middle of the machine, and the bridge wing gate should be on both sides (because the bottom of the middle of the bridge wing gate is closed).
3. Fixed adjustment. The fixed bottom is fixed with 4-M10x100 expansion screws, can not swing, the whole machine is horizontal, the appearance is the same as a whole, (it is best to use a thin line to pull a straight line before fixing, the vertical and horizontal directions are consistent), the wing gate and the wing gate are connected in series, adjusted one by one, and the straight line can be used normally.
